This Auto & Shop Information aptitude Test #1 will assess your knowledge of general automotive and shop techniques and tools. The questions are based on knowledge generally acquired during high school.
There are 10 questions on the test. There is no time limit on the test. You may not skip any of the questions on this assembling objects aptitude test. You must answer all 10 questions in order to receive your score. Your score will be shown immediately after you complete the test.
This is our 1st of 5 different auto & shop information aptitude tests. You’re welcome to take the tests as many times as you’d like. The tests should contain different questions but they will all be of the same difficulty. We have hundreds of general aptitude practice questions in our database. You’re welcome to retake the test as many times as you’d like.
Auto & Shop Information Aptitude Test 1
0 of 10 questions completed
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading…
You must sign in or sign up to start the quiz.
You must first complete the following:
0 of 10 questions answered correctly
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Question 1 of 10
If you hear a loud clanking noise from the rear of a rear-wheel-drive, front-engine car, you should look for trouble at _____CorrectIncorrect
Question 2 of 10
If one engine cylinder does not work right, you should check for problems in the _____CorrectIncorrect
Question 3 of 10
If tire pressure gets low, what will happen?CorrectIncorrect
Question 4 of 10
If an engine with conventional ignition runs rough, what might you adjust on the breaker points?CorrectIncorrect
Question 5 of 10
One important difference between front-wheel drive and rear-wheel drive is that in front-wheel drive _____CorrectIncorrect
Question 6 of 10
Which is the correct sequence in a four-cycle internal combustion engine?CorrectIncorrect
Question 7 of 10
If you suspect that not enough gasoline is entering the engine, what might you check first?CorrectIncorrect
Question 8 of 10
When a manual transmission is in a "direct drive" gear, one revolution of the engine produces